Setup
Q-Beam 260-LED User Manual Rev. 01d -9-
Mounting
Before mounting this fixture, read and follow the safety recommendations indicated in
the Safety Notes section (page 2 of this manual).
Orientation
Always mount this fixture in any safe position while making sure that there is adequate
room around it for ventilation, configuration, and maintenance.
Rigging
CHAUVET® recommends following the general guidelines below when mounting the Q-
Beam 260-LED.
· When selecting an installation location, consider ease of access to the fixture for
operation, programming adjustments, and routine maintenance.
· Make sure to mount this fixture away from any flammable material as indicated in
the Safety Notes section.
· Never mount the fixture in places where rain, high humidity, extreme temperature
changes, or restricted ventilation may affect it.
· If hanging this fixture, make sure that the location where you are mounting the
fixture can support its weight. Please see the Technical Specifications section of this
manual for the weight requirement of this fixture.
Procedure
The Q-Beam 260-LED comes with two omega brackets to which you can attach a
couple of “C” or “O” clamps. You must supply your own “C” or “O” clamps and make
sure that they are capable of supporting the weight of this fixture. You will have to use
two mounting points per fixture. In addition, you may mount this product on the floor or a
platform provided it is stable and it can support the weight of the fixtures on it.
Product Mounting
Diagram
Overhead Mounting
Floor Mounting
Omega brackets (included)
C Clamps (not included)
Safety cable (included)
