D8125INV
Installation
D8125INV Operation and Installation Guide
© 2005 Bosch Security Systems Page 15 49690E
3.5.2 RF System OK
If the system is OK, Figure 10 will appear.
Figure 10: RF System Normal
3.5.3 Call for Service
If one of the following conditions occurs, Figure 11 will appear.
• EEPROM Failed
• Receiver Missing
• Programmed RF Points Missing
see Section 4.0 Troubleshooting, p.29 for more information.
Figure 11: Call for Service
3.5.4 Factory Default Passcode
The D8125INV contains a single passcode. To access the functions in the
D8125INV, this passcode must be entered first. The default passcode loaded at
the factory is 123456 + [ENT]. This passcode may be changed at any time
from within programming mode. To enter the default passcode, press 123456
+ [ENT].
Figure 12: Invalid code display
3.5.4.1 Entering Invalid Passcodes
If an invalid passcode is entered, the D8125INV keypad will display Figure 12.
If an invalid passcode is entered 4 times in row, the keypad will display Figure
13.
The D8125INV will disallow any further entries for 5 minutes, unless power is
cycled to the unit.
Figure 13: Invalid code, Keypad locked
display
