A SERVICE OF

logo

Open as PDF
next previous
EN
21
Preparation
1. Turn the tap on completely. Check if
the hoses are connected tightly.
2. Placethelaundryinthemachine.
3. Add detergent and softener.
Starting
1. Pressthe“On/Off”button.
2. Select the programme and the
temperature.
3. Ifrequired(accordingtoyour
machine’smodel):
– selectanyauxiliaryfunction,
– adjustthespinspeed,
– setthetimedelay,
4. Close the loading door.
5. PressStart/Pause/Cancelbutton.
Canceling a program
• Press“Start/Pause/Cancel”button
for 3 seconds. The machine starts
todischargethewater.“Wash”and
“ProgramFinished”lightswilllight
up.
• “Start/Pause/Cancel”and“Wash”
lights will go off after discharging
processisoverandthe“Lid”light
will start flashing.
• Iftheprogramiscancelledinthe
middleoftheprocess,“Wash”
and“ProgramFinished”lightswill
light up. The machine can drain
all the water or can take in water
for 3 times at most to cool down
the clothes and complete draining
process. When water discharging
processiscompleted,“Wash”light
willgooff,“ProgramFinished”light
willlightupandthe“Lid”lightwill
continuously flash until the door
isallowedtobeopened.Youcan
make a new program selection when
the“Lid”lightislitcontinuously.
Adding more laundry
Youmayaddmorelaundryintothe
machine at the beginning of washing.
CMachineallowsaddingmorelaundry
6 Quick instructions for daily use
during a later step only if the water
level is low enough to open the
loading door or if the temperature in
the machine is low enough.
In order to add laundry after the start-up
oftheprogram:
1. PressStart/Pause/Cancelbutton.
Wait until the door is allowed to open.
“Lid”lampwilllightupcontinuously
when the door is allowed to open.
2. Opentheloadingdoorandputin
more laundry.
3. Close the loading door.
4. PressStart/Pause/Cancelbutton.
Program is in rinse hold mode
C After the machine fills with water in the
final rinse step, clothes can be soaked
in the machine as long as desired.
When it reaches this position while the
machineisrunning,the“Start/Pause/
Cancel”lightwillflash.
In the machines equipped with spin
speed selection knob, you can spin by
selecting the desired spin speed and
press“Start/Pause/Cancel”button.
As for machines not equipped with a spin
speed selection knob, you can end the
program without spinning by pressing
the“Start/Pause/Cancel”buttontodrain
thewater.Youmayspinyourclothes
whenever you wish to by selecting the
spin program.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in the
drum is not balanced.
Ifyouwanttore-spintheclothes:
1. Rearrange the previously placed
clothes in machine.
2. SelectSpin+Pumpprogram.
3. Set the spin speed if spin speed
adjustment is available on your
machine.
4. Press“Start/Pause/Cancel”button.