6. Projector Configuration
6. PROJECTOR CONFIGURATION
Overview
• Set up of the Serial Bus Address
• Set up of the Network Properties
6.1 Set up of the Serial Bus Address
Do not change the serial bus address when connected over a serial loop.
How to set up
1. Click on the + or – button next to the address indication. (image 6-1)
2. Click on Apply now.
The serial bus address will be set, the Apply now button will gray out.
Image 6-1
Serial Bus Address Setting
6.2 Set up of the Network Properties
Overview
• Ethernet Connection
• Assign an Ethernet address via DHCP
• Manually assign an Ethernet address
6.2.1 Ethernet Connection
IP
Internet Protocol. The network layer of TCP/IP. Required for communication with the internet.
Subnet mask
A number that is used to identify a subnetwork so that I
P addresses can be shared on a local
area network.
R5976790 COMMUNICATOR 09/07/2004 39
