- 8 -
Hardware Installation
Before you Begin
Installation of this HDMI switch is simply a matter of plugging in
the appropriate cables.
To install the switch, refer to the installation diagram on the next
page as you perform the following three steps:
1. Use a HDMI cable to connect the HDMI input port on the
video display device to the HDMI output port on the rear of
the switch.
2. Use HDMI cables to connect the HDMI output ports on the
source device(s) to the HDMI input ports on the switch. The
fourth HDMI input port is located on the front of the switch.
3. Plug the provided power adapter into an appropriate AC
power source; plug the power adapter cable into the Power
Jack on the HDMI Switch.
This completes the installation. You may now turn on the display
and source devices.
1. Ensure that all equipment to be connected is
powered off.
2. Make sure that all devices you will be connecting up
are properly grounded.
3. Unplug the power cords of all the computers that
have the Keyboard Power On function.
vs481a.fm Page 8 Tuesday, May 15, 2007 9:02 AM
