Installation
Refer to the diagrams on pages 7 and 8 as you do the following:
1. Plug the Console Adapter Cable into the Console Port
Connector on the rear panel of the CS-72E.
2. Plug your keyboard, monitor and mouse into their respective
connectors on the Console Adapter Cable. Each connector
is marked with an approprieate icon to indicate itself.
3. Use the custom KVM cables (described in the Cables
section on p. 3), to connect the CS-72E CPU Ports to the
monitor, keyboard and mouse ports of the computers you
are installing.
4. If you choose to use external power, plug the power adapter
into an AC power source, then plug the power adapter cable
into the unit’s Power Jack.
Note: The power adapter should be DC9V with the inside
positive and the outside negative:
5. Turn on the power to the computers.
Note: The CS-72E’s default is to link to the first computer
you turn on.
- 6 -
1. Make sure that power to all the devices you will
be connecting up have been turned off. You
must unplug the power cords of any computers
that have the Keyboard Power On function.
2. To prevent damage to your installation due to
ground potential difference, make sure that all
devices on the installation are properly grounded.
2003-07-02
