VII. Operation
...
continued
12
Cutting workpiece (Fig. 11)
1. Set the angle plate (1) to the desired cutting
angle.
2. Make sure the workpiece lies flat on the cut-
off saw table.
3. Use the vise (2) to secure the workpiece to
the table.
4. Squeeze the trigger switch.
5. After the motor reaches full speed, lower the
disc into the centre of the workpiece.
6. Using a smooth, firm, and gentle downward
motion, make a clean cut through the
workpiece. Do not allow the disc to bump or jump when making contact with the
workpiece; this may damage both the workpiece and the disc.
7. Keep consistent pressure when coming to the bottom of the cut to avoid forming a heavy
burr and overheating the workpiece.
8. Raise the disc completely from the workpiece before releasing the trigger switch and allow
the motor to stop before removing the workpiece.
Note: A long workpiece should be supported on both ends with blocks of a non-flammable
material so that the workpiece is level with the cut-off saw table.
Using the laser line (Fig. 12)
1. Secure the workpiece in the vise clamp.
2. Turn the laser switch (1) to the ON position.
3. Check the location of the laser line on the
workpiece. Move the workpiece (2), if
needed.
Fig. 11
1
2
1
2
Fig. 12
WARNING: DO NOT STARE DIRECTLY AT THE LASER BEAM! A HAZARD MAY EXIST
IF YOU DELIBERATELY STARE INTO THE BEAM, PLEASE OBSERVE ALL SAFETY
RULES.
