A SERVICE OF

logo

3 Upgrading your system
64
2 Press your finger to the BPL5M hot-swap cage to release the drive
tray.
3 Remove the four tray screws to open the drive tray. Keep the
screws for later use.
4 When applicable, pull out any previously installed hard disk.
5 Install a hard disk on the drive tray then secure it with the four
tray screws you have removed earlier.
6 Insert the tray into the hot-swap cage with the lever still extended.
Make sure that the drive is properly inserted before closing the
lever.
7 Push the lever back until it clicks into place.
AA G610.book Page 64 Monday, October 22, 2001 9:46 AM