A SERVICE OF

logo

20
3 Connect the power cable to power port on the rear panel of the access point.
4 Position the access point at an angle to the mounting plate bayonet
connection and turn the unit clockwise until it snaps into place, as shown
below.
FLAT SURFACE INSTALLATION
The access point can also be placed on a flat surface such as a table, desktop or
filing cabinet. Do not install the access point on any type of metal surface. If you
choose a flat surface mount, select a location that is clear of obstructions and
provides good reception.
Note: Regulatory restrictions dictate that when this device is operational, the
minimal body-to-antenna distance is 1 Meter (3 Feet).