Installation Checklists 1-3
NETBuilder II Systems
with a DPE Module
Use the following checklist to install software, boot, and configure basic settings
on a NETBuilder II system with a DPE module.
Install System Software and Boot — Refer to Chapter 2.
Change the Primary Boot Source — Refer to Chapter 3
Configure Basic Settings — Refer to Chapter 6.
Configure Specific Services for Your Network — Refer to Using NETBuilder
Family Software and Reference for NETBuilder Family Software.
❑ Install software from a flash memory card.
❑ Change the primary boot source default as needed.
❑ Log on to the system.
❑ Familiarize yourself with the command-line or menu-driven user interface (UI),
storing configuration parameter values, and getting help.
❑ Obtain Network Manager privilege level.
❑ Change the Network Manager password.
❑ Adjust the time and date if necessary. Time and date are preset and may need
to be adjusted for your time zone.
❑ Set system administrator information:
❑ System name and location
❑ System contact name and phone number
❑ Assign IP addresses/subnet masks to individual ports or one address to
the system.
❑ Set up the bridge/router for SNMP.
❑ Set up NETBuilder II system security.
❑ Use the Quick Installation Utility for further configuration.
