Filter
Top Products
3
Specifications
Power Requirements
North American: 117VAC 60 Hz
260 Watts Maximum
European: 230VAC 50 Hz
260 Watts Maximum
Power Amplifier
Power (Internal Amp): 200 Watts
Input Impedance: 80 kohms
Speaker
10"driver, 2-ohm, 200 Watts
Performance
Maximum SPL: 125 dB
Frequency response: 50 Hz to 110 Hz
Input Connections
Input: 1 x 1/4-inch, Output: 1 x 1/4-inch
Tip: Positive, Ring: Negative, Sleeve: Optional
Grounding
The sleeves of the input are not grounded except when the input ground switch is
set to GND. Grounding is done through a 10-ohm protection device in order to
prevent damage due to miswiring.
Limiting
Clipping, Average voice coil current, Thermal
Weight
53 lb. (24 kg)
Dimensions
(HxWxD): 14.0" x 17.5" x 27.1"
35.6 x 44.5 x 68.9 cm
Note: The PS110P built-in stand mounting adapter can be used with Yorkville
SW-Teletube accessory to support our E160 cabinets. The support tube can be adusted up
to it's full 5'4" extension safely as long as the PS110P is not inclined more than 10°.
WARNING: Larger/heavier cabinets should not be used with the stand mount!