Filter
Top Products
3
6. Protection
The LS700P has circuitry to prevent clipping, over current and over excursion. The circuitry
does not alter the frequency response as the level changes. At high levels the limiter will
limit the gain of the LS700P and hence if the user attempts to set the subwoofer level control
at high levels the resulting setting will be incorrect. The level control should be set while
operating at low levels (under 10 watts). If the level control is set to high due to setting it at
high operating levels the input circuit will clip and the dynamics of the bass will be lost. This
can happen without audible distortion since the filters will filter out the distortion.
LS700P CONFIGURATION EXAMPLES
TWO SUBWOOFERS PER SYSTEM
LS700P
SUBWOOFER
LS700P
SUBWOOFER
POWER
AMPLIFIER
FULL–RANGE
SPEAKER
FULL–RANGE
SPEAKER
RightLeft
config02e-ls700p.eps
ONE SUBWOOFER, WITH MONO SYSTEM
LS700P
SUBWOOFER
POWER
AMPLIFIER
FULL–RANGE
SPEAKER/
s
Output
config01e-ls700p.eps
ONE SUBWOOFER, WITH STEREO SYSTEM
LS700P
SUBWOOFER
POWER
AMPLIFIER
FULL–RANGE
SPEAKERS
Left
Right
Lef
t
Right
config03e-ls700p.eps
ONE SUBWOOFER USING ÉLITE PROCESSOR
LS700P
SUBWOOFER
POWER
AMPLIFIER
élite
PROCESSOR
FULL–RANGE
SPEAKERS
Lef
t
Right
R
L
INPUT INPUT
AMP OU
TAMP IN
MID/
HI
SUB
OU
T
SUB
OUT
MID/
HI
L
R
config04e-ls700p.eps
Note: The LS700P built-in stand mounting adapter can be used with Yorkville SW-Teletube accessory to support our
E160 cabinets. The support tube can be adusted up to it’s full 5’4” extension safely as long as the LS700P is not
inclined more than 10˚ (10 degrees).
WARNING:
Larger or heavier cabinets
should not be used!