Filter
Top Products
3
Specifications
Power Requirements
North American: 117VAC 60 Hz
260 Watts Maximum
European: 230VAC 50 Hz
260 Watts Maximum
Power Amplifier Power (internal):
200 Watts
Frequency response: 50 Hz to 110 Hz
Input Impedance: 80 kohms
Speaker components: 10" 2-ohm, 200 Watts
Input Connections:
Tip: Positive
Ring(Shaft): Negative
Grounding:
The sleeves of the input are not grounded except when the input ground switch is
set to GND. Grounding is done through a 10-ohm protection device in order to
prevent damage due to miswiring.
Limiting:
Clipping, average voice coil current, thermal
Maximum SPL:
125 dB (50 Hz to 110 Hz)
Weight:
54 lb. (24.5 kg)
Dimensions:
(WxDxH): 17.5 x 27 x 14 inches
XX... 44.5 x 68.6 x 35.6 cm
Note: The es200p built-in stand mounting adapter can be used with Yorkville
SW-Teletube accessory to support our E160 cabinets. The support tube can be adusted up to
it's full 5'4" extension safely as long as the es200p is not inclined more than 10° (10 degrees).
WARNING: Larger/heavier cabinets should not be used with the stand mount!