Yamaha YST-SW20 Speaker User Manual


  Open as PDF
of 6
 
3
Controls
Front Panel
1POWER Switch and Indicator: Press to power on the
YST-SW20; the power indicator will light up. Press again to power
off. Before powering on and off, turn down the VOLUME control.
2HIGH CUT Switch: This switch selects the high-cut filter
frequency: Set it to either LOW or HIGH.
3VOLUME Control: Use this control to set the volume level. Turn
it clockwise to increase the volume, and counterclockwise to
reduce it.
Auto Power On/Off Function
When powered on, if no input signal is received after 5–10 minutes,
the power is switched off automatically. When an input signal is
received, the power is switched back on automatically. This
function works only when the power switch is in the on position.
Note: The power may switch off automatically when the input signal
level is very low. If this does occur, increase the output level from the
source device and reduce the YST-SW20 VOLUME control accordingly.
Rear Panel
4LINE 1 IN: This 3.5 mm stereo jack connection is for inputting
line-level signals to the YST-SW20.
5LINE 1 OUT: This connection can be used to feed the input signal
to other equipment.
6LINE 2: These RCA-pin jacks are for inputting speaker level
signals to the YST-SW20. They can be connected directly to the
speaker outputs of a stereo amplifier.
ACTIVE SERVO PROCESSING
SUBWOOFER SYSTEM YST-SW20
Active Servo
Technology
POWER
HIGH CUT
VOLUME
HIGH
LOW
1
2
3
4
5
6
IN
OUT
LINE 1
LINE 2
L
R
 previous next