Filter
Top Products
English
E-5
AC IN
ON
POWER
OFF
HIGH
LOW
OFF
AUTO
STANDBY
OUTPUT
INPUT
REMOTE
OUTPUT
TO SPEAKERS
INPUT
1
FROM AMPLIFIER
100Hz80Hz
/MONO
NORMAL
INPUT
2
INPUT
3
LFE
GND
H.P.F.OUTPUT
AC IN
ON
POWER
OFF
HIGH
LOW
OFF
AUTO
STANDBY
OUTPUT
INPUT
REMOTE
OUTPUT
TO SPEAKERS
INPUT
1
FROM AMPLIFIER
100Hz80Hz
/MONO
NORMAL
INPUT
2
INPUT
3
LFE
GND
H.P.F.OUTPUT
OUTPUT
TO SPEAKERS
INPUT
1
FROM AMPLIFIER
100Hz80Hz
/MONO
NORMAL
INPUT
2
INPUT
3
LFE
GND
H.P.F.OUTPUT
SPLIT SUBWOOFER
OUTPUT
TO SPEAKERS
INPUT
1
FROM AMPLIFIER
100Hz80Hz
/MONO
NORMAL
INPUT
2
INPUT
3
LFE
GND
H.P.F.OUTPUT
Ⅵ Using two subwoofers
Notes
● Some amplifiers have line output terminals labelled PRE
OUT. When you connect the subwoofer to the PRE OUT
terminals of the amplifier, make sure that the amplifier
has at least two sets of PRE OUT terminals. If the
amplifier has only one set of PRE OUT terminals, do not
connect the subwoofer to the PRE OUT terminals.
Instead, connect the subwoofer to the speaker output
terminals of the amplifier. (Refer to pages 6 and 7.)
● When connecting to a monaural line output terminal of
the amplifier, connect the L/MONO INPUT2 terminal.
● When connecting to line output terminals of the amplifier,
other speakers should not be connected to the OUTPUT
terminals on the rear panel of the subwoofer. If
connected, they will not produce sound.
Right
subwoofer
Amplifier
Mono pin cables
(not included)
Left main speaker
Right main speaker
Left
subwoofer
Ⅵ Connecting to the LFE (INPUT3) terminal(s)
If your amplifier can cut off high frequencies from the signals for sending to the
subwoofer, connect the amplifier to the subwoofer’s LFE (INPUT3) terminal(s). This
will bring you higher sound quality because the signal routing in the subwoofer is
shortened bypassing the built-in HIGH CUT circuit.
F
/MONO
NORMAL
INPUT
2
INPUT
3
LFE
2-SW1500(UB) (02.9.2)a 02.9.2, 6:46 PM5