Filter
Top Products
25
English
1
Set to the “
∞
” position.
2 Turn the power on.
3 Select the desired input source by using the input
selector buttons.
(For video sources, turn the TV/monitor ON.)
* The name of the selected input source will appear on
the display.
4 Select the main speakers to be used.
* If you use two main speaker systems, press both the A
and B switches.
5 Play the source. (For detailed information on the
tuning operation, refer to page 29.)
6
Adjust to the desired output level.
7 If desired, adjust the BASS, TREBLE and BALANCE
controls (refer to page 28), and use the digital sound
field processor. (Refer to page 34.)
Notes on using the input selector buttons
●
Note that pressing on each input selector button selects
the source which is connected to the corresponding input
terminals on the rear panel.
●
The selection of TAPE/MD MONITOR (MON) cannot be
canceled by pressing another input selector button. To
cancel it, press TAPE/MD MONITOR (MON) again so that
the “TAPE MON” indicator disappears from the display.
When you select a button other than TAPE/MD
MONITOR (MON), make sure that the “TAPE MON”
indicator is not illuminated on the display.
●
If you select the input selector button for a video source
without canceling the selection of TAPE/MD MONITOR
(MON), the playback result will be the video image from
the video source and the sound from the audio tape (or
MD etc.).
●
Once you play a video source, its video image will not be
interrupted even if the input selector button for an audio
source is selected.
When you finish using this unit
Press the STANDBY/ON switch again to turn this unit into the
standby mode.
BASIC OPERATIONS
TO PLAY A SOURCE
l6
20
28
40
60
l2
8
4
2
0
–dB
VOLUME
SPEAKERS
A
ON
OFF
B
l6
20
28
40
60
l2
8
4
2
0
–dB
VOLUME
TUNER
CD
PHONO
STANDBY/ON
1, 6
2
4
7
l6
20
28
40
60
l2
8
4
2
0
–dB
3