Yamaha NS-P320 Speaker User Manual


 
E-4
Place the speaker on TV whose top is flat or on the floor
under the TV or inside the TV rack so that it is stabilized.
When placing the speaker on top of the TV, to prevent the
speaker from falling down, put the provided fasteners at four
points on the bottom of the speaker and the top of the TV.
Placing the center speaker
The screw holes (at an interval of 60 mm) on the
bottom and the rear of the speaker can be used to
mount the speaker on a speaker stand.
* Those screw holes can be used with M4 screws
only.
If you want to mount a speaker on a commercially available speaker stand
(for the main/rear speakers)
60 mm
Notes
Do not place the speaker on top of the TV whose
area is smaller than the bottom area of the speaker.
If placed, the speaker may drop out causing an
injury to you.
Do not place the speaker on top of the TV with an
inclination.
Do not touch the adhesive surface after peeling off
the seal as this will weaken its adhesive strength.
Thoroughly wipe clean the surface where the
fastener is to be applied. Note that adhesive strength
is weakened if the surface is dirty, oily or wet and
that this may cause the center speaker to drop.
Screen
Peel off
the seal
Fastener
60 mm
Main speaker
(bottom)
Rear speaker
(bottom)
60 mm
60 mm
Main speaker
(rear)
Rear speaker
(rear)