Yamaha 5650 Stereo System User Manual


 
41
English
ADVANCED
OPERATION
SOUND 2 SP DISTANCE
(speaker distance)
Use this feature to adjust the delay applied to center and
rear center channel sounds. This feature works when there
is sound output from the center speakers with a source
such as Dolby Digital or DTS. Ideally, the center speaker
and the rear speakers should be the same distance from
the main listening position as the left and right main
speakers. However, in most home situations, the center
speaker or the rear center speaker is placed in line with
the main speakers or the rear speakers. By delaying the
sound from the center speaker and the rear speakers, you
can adjust the apparent distance from the center speaker
and the rear speakers to the main listening position to
make it seem the same as the distance between the
listening position and main left and right speakers.
1 Press u / d to select “UNIT”.
2 Press j / i to select the unit “meters” or
“feet” to be used in setting.
3 Press u / d to select the speaker for which
you want to adjust the delay.
4 Press j / i to set the delay.
Press i for higher values and j for lower values.
Setting by “meters”
Control range: 0.3 to 24.00 m (for main L/R,center,
rear L/R, rear center)
Initial settings: 3.00 m (for main L/R, center, rear L/
R), 2.10 m (for rear center)
Setting by “feet”
Control range: 1 to 80 ft (for main L/R, center, rear
L/R, rear center)
Initial settings: 10.0 ft (for main L/R, center, rear L/
R), 7.0 ft (for rear center)
Note
No delay will be set if you set the same distance for the main
L/R and center, or the rear L/R and rear center.
L
C
C
RC
R
RL
RR
RL
RR
RC
SOUND 3 LFE LEVEL
Use this feature to adjust the output level of the LFE
(low-frequency effect) channel when playing back a
Dolby Digital or DTS signal. The LFE signal carries low-
frequency special effect sound which is only added to
certain scenes.
Control range:
SPEAKER ............ –20 to 0 dB
HEADPHONE .....–20 to 0 dB
Initial setting: 0 dB
1 Press u / d to select the item to be
adjusted.
2 Press j to adjust the LFE level.
Note
Adjust the LFE level according to the capacity of your
subwoofer or headphones.
SOUND 4 D. RANGE
(dynamic range)
Use this feature to adjust the dynamic range. This setting
is effective only when the unit is decoding Dolby Digital
signals.
Choices: MAX, STD (standard), MIN (minimum)
MAX
Select MAX for feature films.
STD
Select STD for general use.
MIN
Select MIN for listening to sources at low volume levels.
SET MENU
0108HTR5650/5640_38-44_EN-U.p65 02.12.24, 9:27 AM41