Yamaha HTR-5240 Stereo System User Manual


 
40
Example: To control YAMAHA CD
player
1 Make sure that VOLUME is set to the “m
position.
2 Press AMP(TUNER) on the
component selector.
3 Turn on the power.
4 Press CD on the input selector.
PRESET REMOTE CONTROL
The provided remote control is factory set to control not only this unit but also most YAMAHA audio components connected
to it.
There are eight component selector buttons. Press one of these buttons which corresponds to the component you want to
control with the remote control. For example, if you press CD on the component selector, the remote control is set to the CD
operation mode, allowing the CD player to be controlled by the buttons on the remote control.
5
3
2
4
7
6
AMP(TUNER)
You can perform the basic operations of this
unit. Refer to page 7.
CD
The code for a YAMAHA CD player is
factory set.
DVD/LD & DVD MENU
An LD player can be controlled in
the DVD/LD mode. A DVD player can be
controlled in the DVD/LD and DVD
MENU modes. The code for a YAMAHA
DVD player is factory set. If the remote
control does not operate your YAMAHA
DVD player, you need to set the code
number “0048”.
TAPE/MD
The code for a YAMAHA tape deck is
factory set. (The code for the YAMAHA
MD recorder can also be set.)
VCR
A VCR can be controlled.
TV
A TV can be controlled.
CBL/SAT
A cable TV or satellite tuner can be
controlled.
Note
The button functions on the remote control differ depending on the operation mode. Refer to the following pages for details.
Controlling the Components Connected to This Unit
5 Press CD on the
component selector.
6 Press p.
Refer to page 42 for the CD
player operation buttons.
7 Adjust the volume.
If you set the remote control with the manufacturers’
codes listed from page i at the end of this
manual, you can control other brands of components.
Refer to “Setup codes” on page 45 for details.
0109V49640-46_EN(UCA) 1/11/0, 10:35 AM40