Filter
Top Products
11
English
PREPARATION
ADJUSTING SPEAKER OUTPUT LEVELS
3 Adjust the level of each speaker by pressing
VOLUME +/– so that it matches the level of
the front speakers.
While adjusting, the test tone is heard from the
selected speakers. After – or + is released, the test
tone begins travelling to another speaker again.
4 When adjustment is complete, press TEST to
stop the test tone.
• While adjusting, the level of the selected speaker is shown
by the lighting of the VOLUME indicators on the front
panel. The default level is also shown by the dim lighting
of the corresponding indicator.
y
• You can enjoy listening to the input source at the desired
volume simply by turning VOLUME on the front panel or
pressing VOLUME +/– on the remote control.
Notes
• If you press INPUT on the remote control when the test tone is
outputted, the output levels of all channels are reset to the
default levels.
• The levels of the left and right front speakers cannot be set over
the point on the VOLUME indicator shown in the figure below.
This section explains how to adjust speaker output levels
using the test tone generator. When this adjustment is
complete, the output level heard at the listening position
should be the same from each speaker. This is important
for best performance of the various decoders (Dolby
Digital, Dolby Pro Logic II and DTS).
Note
• Since this system cannot enter the test mode while headphones
are connected to the amplifier unit, be sure to unplug the
headphones from the
SILENT jack when using the test
tone.
Using the test tone
Use the test tone to balance the output levels of the
speakers.
Notes
• The adjustment of each speaker output level should be made at
your listening position using the remote control.
• The test tone may not be heard if the volume level of this
system is too low. Confirm that the volume is set to a proper
listening level.
1 Press to turn on the power.
2 Press TEST to output the test tone.
The test tone is heard (in order) from the left front,
center, right front, right rear and left rear speaker.
The tone is produced for about 2.5 seconds from
each speaker.
• All of the INPUT indicators flash while the test tone is
being outputted.
INPUT
MODE
REAR
MUTE
TEST
S.WOOFER
VOLUME
VOLUME +/–
TEST
Right frontLeft front
Right rear
Left rear
Center
VOLUME
7
6
5
4
3
2
1
+6
+4
+2
0
–2
–4
–6
TRIM
PL MOVIE
PL
MUSIC
SILENT
DIGITAL 1
DIGITAL 2
ANALOG
DTS
INPUT
MODE
VOLUME
DIGITAL
7
6
5
4
3
2
1
+6
+4
+2
0
–2
–4
–6
TRIM
PLMOVIE
PL
MUSIC
STANDBY/ON
TSS-10Eng(UB)a 02.7.31, 2:35 PM11