Filter
Top Products
E-3
English
When using a banana plug
1 Remove the cover by pulling it toward you.
2 Tighten the terminal knob.
3 Simply insert the banana plug into the terminal.
Banana plug
2
3
SPECIFICATIONS
Type .............. 2-way acoustic suspension speaker system
Magnetic shielding type
Driver ...................................... 10 cm (4”) cone woofer x 2
3 cm (1”) dome tweeter
Impedance ................................................................... 6 Ω
Frequency Response ...................60 Hz to 50 kHz (-10dB)
Nominal Input Power................................................... 50W
Maximum Input Power .............................................200 W
Sensitivity .................................................. 88 dB/2.83 V/m
Crossover Frequency............................................. 2.5 kHz
Dimensions (WxHxD).........................430 x 140 x 200 mm
(16-15/16” x 5-1/2” x 7-7/8”)
Weight ................................................5.4kg (11 lbs.14 oz.)
● Specifications subject to change without notice due to
product improvements.
● Care should be taken not to exceed the input power
values noted above.
REMOVING THE FRONT COVER
The front cover is fastened to the enclosure at four points
and can be removed if desired. To remove the cover, hold
on to both sides and slowly pull straight away from the
speaker. To reattach, line up the four holes on the inner
surface of the cover with the four corresponding pegs on
the speaker and push gently.
Note:
When the cover is removed, take care not to touch the
speaker units with your hands or to exert excessive
force with tools.
1