Filter
Top Products
15
English
PREPARATION
VIDEO AUX
S VIDEO VIDEO L AUDIO R
S VIDEO
L
R
VIDEO
VIDEO OUT
S VIDEO OUT
AUDIO OUT L
AUDIO OUT R
Camcorder
For Custom Installer (
For U.S.A., Canada and Australia models only)
(U.S.A. model)
VIDEO AUX terminals (on the front panel)
These terminals are used to connect a video input source such
as a camcorder.
PAL/NTSC switch (China and General
models only)
This unit is designed for use with the NTSC and PAL television
formats. Set this switch to the position for the format your TV
monitor employs.
PAL: Set to this position if your TV monitor employs the PAL
format.
Outputs signals in the PAL format no matter which
format (PAL or NTSC) of video signal is sent from an
external video unit to this unit.
NTSC: Set to this position if your TV monitor employs the
NTSC format.
Outputs signals in the NTSC format no matter which
format (PAL or NTSC) of video signal is sent from an
external video unit to this unit.
Note
Be sure to input a video signal which employs the same format
that your TV monitor employs, otherwise a picture will not be
played back normally.
Ω
UNBAL.
GND
SUB
WOOFER
S VIDEO VIDEO
PAL NTSC
DVD/LD
COAXIALOPTICAL OPTICAL
DVD/LD TV/DBSCD
DIGITAL SIGNAL
EXTERNAL DECO
MAIN CENTER
ON SCREEN SELECTOR
GND
SUB
WOOFER
ON SCREEN SELECTOR
S VIDEO VIDEO
REMOTE
CONTROL
IN OUT
DVD/LD
COAXIALOPTICAL OPTICAL
DVD/LD TV/DBSCD
DIGITAL SIGNAL
EXTERNAL DECODER INPUT
MAIN CENTER
SURROUND
REMOTE CONTROL (IN, OUT) terminals
These terminals are used for custom installation system.
When this unit is connected to the components for custom
installation system, you can operate this unit with the system
remote control.
Connect the REMOTE CONTROL IN terminal of this unit to
the output terminal of the central controller for custom
installation system.
By connecting the REMOTE CONTROL OUT terminal of this
unit to the REMOTE CONTROL IN terminal of the other
component, you can also operate it with the system remote
control. In this way, up to 6 components can be connected in
series.
: S-video cable
(Refer to page 18 for details about the S
VIDEO terminal.)