Filter
Top Products
43
English
ADVANCED
OPERATION
SOUND 2 SP DISTANCE
(speaker distance)
Use this feature if the distance from the listening position
to each effect speaker (center, rear, rear center) is
different from that from the listening position to the main
speakers. To obtain maximum effect from multi-channel
source, all speakers should be located the same distance
from the listening position. However, the center speaker is
often placed in line with the main speakers. You can set
this unit to automatically adjust the sound delay for each
speaker so that all channel sounds reach your listening
position simultaneously, by inputting the distances
between the listening position and each main L/R, center,
rear L/R and rear center speaker.
1 Press u / d to select “UNIT”.
2 Press j / i to select the unit “meters” or
“feet” to be used in setting.
3 Press u / d to select a speaker.
4 Press j / i to set the distance.
Press i for higher values and j for lower values.
■ Setting by “meters”
Control range: 0.3 to 24.00 m (for main L/R,center,
rear L/R, rear center)
Initial settings: 3.00 m (for main L/R, center, rear L/
R), 2.10 m (for rear center)
■ Setting by “feet”
Control range: 1 to 80 ft (for main L/R, center, rear
L/R, rear center)
Initial settings: 10.0 ft (for main L/R, center, rear L/
R), 7.0 ft (for rear center)
Note
• No delay will be set if you set the same distance for the main
L/R and center, or the rear L/R and rear center.
L
C
C
RC
R
RL
RR
RL
RR
RC
SOUND 3 LFE LEVEL
Use this feature to adjust the output level of the LFE
(low-frequency effect) channel when playing back a
Dolby Digital or DTS signal. The LFE signal carries low-
frequency special effect sound which is only added to
certain scenes.
Control range:
SPEAKER ............ –20 to 0 dB
HEADPHONE .....–20 to 0 dB
Initial setting: 0 dB
1 Press u / d to select the item to be
adjusted.
2 Press j to adjust the LFE level.
Note
• Adjust the LFE level according to the capacity of your
subwoofer or headphones.
SOUND 4 D. RANGE
(dynamic range)
Use this feature to adjust the dynamic range. This setting
is effective only when the unit is decoding Dolby Digital
signals.
Choices: MAX, STD (standard), MIN (minimum)
MAX
Select MAX for feature films.
STD
Select STD for general use.
MIN
Select MIN for listening to sources at low volume levels.
SET MENU
0108RX-V640_40-46_EN-GB.p65 2003.04.01, 10:2843