Filter
Top Products
45
English
1 To clear a learned key function, press the LEARN button
using the point of a mechanical pencil, etc.
To clear a macro you made, press the MACRO button.
2 Press and hold the CLEAR button using the point of a
mechanical pencil, etc.
3 Holding the CLEAR button pressed, press and hold the
key whose function you want to clear until the indicator
flashes 3 times.
To clear two or more functions sequentially, do not
release the CLEAR button pressed, and repeat this step.
Note
If you clear a learned function of a key, the originally preset
function of the key is restored (except the keys which are
originally preset with no function.)
To Clear a Learned Function To Clear All Learned Functions
1 Select the kind of key functions all of which you want to
clear by using the MACRO switch on the side panel of
the remote control transmitter.
OFF: Select this position if you want to clear all of the
learned functions except macros.
QUICK: Select this position if you want to clear all of the
macros you made only.
SLOW: Select this position if you want to clear all of the
learned functions including macros.
2 Press the CLEAR button using the point of a
mechanical pencil, etc.
* If one of the following operation is made after you press
the CLEAR button, the TRANSMIT/LEARN indicator
flashes rapidly and the current mode is canceled. If this
occurs, press the CLEAR button again.
• MACRO switch is switched to another position.
• Another key is pressed.
• There is no operation for about 30 seconds.
3 Press and hold the CLEAR button again. While holding
the CLEAR button pressed, press and hold the
MASTER VOLUME and keys simultaneously
until the indicator flashes 7 times.
SYMPTOM
The remote control transmitter does not
work.
Learning cannot be made successfully.
(The TRANSMIT/LEARN indicator does not
light up or flash.)
CAUSE
The batteries of this remote control
transmitter are weak.
The internal microcomputer “freezes”.
The batteries of this remote control
transmitter and/or the other remote control
transmitter are weak.
The distance between the two remote control
transmitters is too long or too short.
The signal coding or modulation of the other
remote control transmitter is not compatible
with this remote control transmitter.
Memory capacity is full.
The internal microcomputer “freezes”.
REMEDY
Replace the batteries with new ones and
press the RESET button on the remote
control transmitter.
Replace the batteries (and press the RESET
button for this remote control transmitter).
Place the remote control transmitters with the
proper distance.
Learning is not possible.
Further learning is not possible without
deleting unnecessary commands.
Press the RESET button on the remote
control transmitter.
Trouble shooting guide
MACROQUICK
OFFSLOW
CLEARING LEARNED FUNCTIONS
TRANSMIT
/LEARN
LEARNCLEAR MACRO
LEARNCLEAR MACRO
Flashes slowly.
or
CD
TRANSMIT
/LEARN
Flashes.
LEARNCLEAR MACRO
TRANSMIT
/LEARN
Flashes slowly.
TRANSMIT
/LEARN
Flashes.