Filter
Top Products
53 En
Remote control features
ADVANCED
OPERATION
English
You can control other components by setting the
appropriate remote control codes. For a complete list of
available remote control codes, refer to “List of remote
control codes” at the end of this manual.
Remote control code default settings
You may not be able to operate your Yamaha component even if a
Yamaha remote control code is preset as listed above. In this case,
try setting another Yamaha remote control code.
1 While pressing and holding one of the input
selector buttons (
3
) on the remote control to
select the input area you want to set up,
press
2
AV POWER for more than 3
seconds.
2 Press the numeric buttons (0 to 9) (
N
) to
enter the four-digit remote control code for
the component to be used.
When the setting succeeds, “RemoteSetup OK”
appears; however, when it dues not, “RemoteSetup
NG” appears in the front panel display.
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• If you do not press any buttons within 30 seconds in step 2, the
setup process is canceled. If this happens, repeat the setup
procedure.
■ Resetting all remote control codes
Use this feature to clear all the remote control codes
previously set and reset all of them to the initial factory
settings.
1 While pressing and holding
4
AMP, press
2
AV POWER for more than 3 seconds.
2 Press the numeric buttons (
N
) to enter the
code number “9981”.
“RemoteSetup OK” appears in the front panel
display, and the remote control codes previously set
are cleared and reset to the initial factory settings.
y
If you do not press any buttons within 30 seconds after
step 1, the clearing process is canceled. In this case, repeat
the clearing procedure.
Setting remote control codes
Input
source
Component
category
Manufacturer
Default
code
CD CD Yamaha 5013
MD/CD-R CD-R Yamaha 5001
TUNER TUNER Yamaha 5007
DVD DVD Yamaha 2000
DTV/CBL — — —
V-AUX/D
OCK
TUNER Yamaha 5011
DVR DVR Yamaha 2011
A TUNER Yamaha 5012
B TUNER Yamaha 5009
C TUNER Yamaha 5017
D— ——
E— ——
Note
DVD
V-AUX/DOCK
DE
DTV/CBL DVR
CD MD/CD-R
TUNER
A BC
POWER
AV
While holding down
Press for 3
seconds
Notes
POWER
AV
AMP
While holding
down
Press for 3
seconds
01EN_RX-V363_U.book Page 53 Thursday, January 31, 2008 3:52 PM