Yamaha RL RX-E100 CD Player User Manual


 
E-24
ADD KX-E100 AND/OR MDX-E100 TO YOUR SYSTEM
There are six different combinations of components. Once
you choose a certain mode, recording starts and ends
automatically in a certain way for each mode.
Before recording
When you record by using MDX-E100 or KX-E100, you
must first make the connections as shown in “Connecting
the system” on page 5. For details, refer to the instructions
supplied with the MDX-E100 or KX-E100. A source from
the component which is connected to the AUX terminal
component can be recorded on a tape or MD.
Dubbing setting
TAPE
MD REC
MODE START
TAPE REC
DUBBING
DUBBING
START
DUBBING
MODE
1
2
5
6
Only the first track is recorded. After recording the
CD tray opens automatically.
Same as CD (Tr1) = TAPE
Same as CD = TAPE
Recording automatically starts at the beginning of
the tape. (By pressing DUBBING START, the
tape automatically rewinds to the beginning if it is
in the middle.)
2 Press DUBBING START to start recording.
Note
The displays 1~6 which include the component you have not
connected to your receiver (RX-E100) will be skipped.
1 Decide the combination of the components. Each
time you press DUBBING MODE, the mode will
change in the below order.
Recording automatically starts from the beginning
of the tape. (By pressing DUBBING START, the
tape automatically rewinds to the beginning if it is
in the middle.)
When the recording on side A finishes while a
track is being played back, the recording on side B
starts from the beginning of the same track.
The sound is automatically faded out when it gets
close to the end of side B.
3
4
Record unit
Play unit
Record unit
Play unit