Filter
Top Products
4
■ Modes: STEREO/PARALLEL/BRIDGE
BRIDGE mode
In this mode, the CHANNEL A input signal will be
output from the BRIDGE output jacks. In this case, use
the front panel (channel)
A
volume control to adjust the
volume.
■ SPEAKER IMPEDANCE
In STEREO and PARALLEL modes, the minimum load
(=speaker) impedance is 4Ω. In BRIDGE mode it is 8Ω.
Make sure that the impedance does not fall below this
specified impedance.
STEREO mode connections
SPEAKERS
CHANNEL B CHANNEL A
BRIDGE
STEREO PARALLEL
STEREO
BRIDGE
MAX. OUTPUT 450W/4Ω (STEREO)
MAX. OUTPUT 900W/8Ω (BRIDGE)
–+
–+
Set to STEREO
Speaker S
y
stem
4Ω min. 4Ω min.
PARALLEL mode connections
SPEAKERS
CHANNEL B CHANNEL A
BRIDGE
STEREO PARALLEL
STEREO
BRIDGE
MAX. OUTPUT 450W/4Ω (STEREO)
MAX. OUTPUT 900W/8Ω (BRIDGE)
–+
–+
Set to PARALLEL
Speaker S
y
stem
4Ω min. 4Ω min.
BRIDGE mode connections
SPEAKERS
CHANNEL B CHANNEL A
BRIDGE
STEREO PARALLEL
STEREO
BRIDGE
MAX. OUTPUT 450W/4Ω (STEREO)
MAX. OUTPUT 900W/8Ω (BRIDGE)
–+
Set to BRIDGE
Speaker S
y
stem
8Ω min.
STEREO mode
In this mode, channels A and B operate independently
(as a conventional stereo amp).
The CHANNEL A input signal will be output from the
CHANNEL A output jacks, and the CHANNEL B input
signal will be output from the CHANNEL B output
jacks.
PARALLEL mode
In this mode, the CHANNEL A input signal will be
output from the output jacks of both channels A and B.
The CHANNEL B input jack is not used. The (channel)
A
and volumes can be adjusted independently.