Yamaha NX-U10 Speaker System User Manual


 
5 En
English
y
You cannot insert the battery holder into this unit when connecting
the USB plug. Unplug the USB cable from this unit before inserting
the battery holder.
1 Insert 4 commercially available AAA, R03,
UM-4 batteries (alkaline or nickel-hydride
batteries) into the battery holder.
Make sure you insert the batteries according to the
polarity markings (+ and –).
2 Turn the battery holder upside-down.
3 Press and hold the concave portion on the
stand and open it upward.
4 Insert the battery holder into this unit.
5 Connect an audio output jack of your
portable audio player and the PORTABLE
jack of this unit using the supplied 3.5 mm
stereo mini plug cable.
6 Put this unit on a flat surface (a desk etc.)
using the stand.
When setting up this unit, do not apply force to the top of this
unit. Doing so may cause damage or break the stand.
When removing the battery holder
Push down the hook, and then slide the battery holder
rightward to remove the battery holder.
About batteries
We recommend using alkaline or nickel-hydride batteries.
Manganese batteries provide short battery life.
Do not use an old battery together with a new one.
Do not use different types of batteries (such as alkaline and
nickel-hydride batteries) together. Each type of battery has its
own characteristics even if they are similar in shape.
When not planning to use this unit for long periods of time (for
more than 1 month), remove the batteries from the battery holder.
If the batteries have leaked, dispose of them immediately. Avoid
touching the leaked material or letting it come into contact with
clothing, etc. Clean the battery compartment thoroughly before
installing new batteries.
Do not throw away batteries with general house waste; dispose of
them correctly in accordance with your local regulations.
3 When using batteries
1
2
3
5
4
Computer, Portable
audio player etc.
The supplied 3.5 mm stereo mini plug cable
Battery holder
Check
Turn the battery
holder upside-down.
Hook
6
Concave portion
Protrusions A
Battery holder
Metal plates
1With the front protrusions A of the battery holder
being aligned with the protrusions
B of the battery
holder tray on the right, snap the battery holder into
the battery holder tray by pressing down the near
side first.
2Press down the far side of the battery holder into
place with a click.
3Slide the battery holder to the left. Next, make sure
that the battery holder is hooked securely.
Protrusions B
Note
Notes
Hook