Filter
Top Products
4
INSTALLATION
1
Position the cutout template
where you are installing the
speaker. Make sure the
template is level, then trace
around the template with a
pencil.
2
Drill a pilot hole in the center
outline you traced.
3
Insert the bent coat hanger
wire into the hole. Then
slowly rotate to check for any
obstruction. If there is any
obstruction, patch the hole
and select another location.
4
Cut the wall along the outline
you traced.
5
Run high quality speaker
cable from your receiver to
the speaker. Leave a few
extra feet of cable.
Note:
You can insulate the cavity by
placing a sheet of fiberglass
insulation around the speaker
components to improve
speaker performance.
Before installation, check to ensure that the area you are installing the speaker is free of any wall studs, by
tapping the wall or using a stud finder.
If you wish to paint the speaker frame and grill, please refer to page 7 “PAINTING THE SPEAKER FRAME AND
GRILL” before proceeding.
360
o
TEMPLATE