Filter
Top Products
4
INSTALLATION
1
Position the cutout template where you are
installing the speaker. Make sure the template is
level, then trace around the template with a
pencil.
2
Drill a pilot hole in the center outline you traced.
3
Insert the bent coat hanger wire into the hole.
Then slowly rotate to check for any obstruction.
If there is any obstruction, patch the hole and
select another location.
4
Cut the wall along the outline you traced.
5
Run high quality speaker cable from your
receiver to the speaker. Leave a few extra feet of
cable.
Note:
You can insulate the cavity by placing a sheet of
fiberglass insulation around the speaker
components to improve speaker performance.
Before installation, check to ensure that the area you are installing the speaker is free of any wall studs, by
tapping the wall or using a stud finder.
If you wish to paint the speaker frame and grill, please refer to page 7 “PAINTING THE SPEAKER FRAME AND
GRILL” before proceeding.