Yamaha NS-AP9500M Speaker System User Manual


 
NS-AP9500M/9600E
7
CONNECTIONS TO THE RECEIVER
CONNECTIONS
Check to make sure that the receiver has been turned off before making any speaker connections.
Connect the (+) terminal of the receiver to the (+) terminal of the speaker.
Connect the (–) terminal of the receiver to the (–) terminal of the speaker.
Reversing polarity (+/–) will result in unnatural sound reproduction.
PROCEDURE
For connections, keep the speaker cords as short as possible. Do not bundle or roll up the excess part of the
cords. If the connections are faulty, no sound will be heard from the speakers. Make sure that the + and – polarity
markings of the speaker cords are observed and set correctly. If these cords are reversed, the sound will be
unnatural and lack bass.
How to Connect:
Front and Center speakers
1 Loosen the knob.
2 Insert the bare wire. Remove the insulation
coating at the extremity of each speaker cable
by twisting the coating off.
3 Tighten the knob and secure the cable. Test the
firmness of the connection by pulling lightly on the
cable at the terminal.
When using a banana plug
1 Remove the cover by pulling it toward you.
2 Tighten the terminal knob.
3 Insert the banana plug into the terminal.
Surround speakers
1 Press and hold the terminal’s tab.
2 Insert the bare wire into the terminal hole. Remove the insulation
coating at the extremity of each speaker cable by twisting the
coating off.
3 Release your finger from the tab to allow it to lock securely on the
bare wire end.
4 Test the firmness of the connection by pulling lightly on the cord at
the terminal.
Note
Do not let the bare speaker wires touch each other as this could damage the speaker, the amplifier, or both.
Loosen
Tighten
Red (+)
Black (–)
(–) (+)
3
1
2
3
1
2
Banana plug
2
1 3