Filter
Top Products
4
SETTING UP THE SPEAKERS
Attaching the non-skid pads to the speakers
Place the speakers on a sturdy, vibration-free surface, such as a well-built stand. Attach the included non-skid
pads to the bottom of the speakers to prevent the speakers from slipping.
Wall mounting the front and/or surround speakers
When mounting the speakers on a wall, attach one of the non-skid pads provided near each of the corners on
the rear surface of the speaker to prevent the speaker cable from being caught between the wall and the
speaker.
Youcan also usethe screw holes onthe back of thespeaker for
installing the speakerson commercially available speakerbrackets.
2-3/8
(60 mm)
A screw witha diameter of
canbe used.
(Hole depth:9/32 )
Wall /wall support
Tapping screw
(Available atthe hardware store)
When using speakerbrackets to mount thespeakers on a wallor ceiling, it isstrongly recommended that
safety wire, whichmay be included withthe bracket, be usedbetween the speaker andthe bracket to prevent
the speaker fromfalling.
Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting
bracket on the protruding screws.
Make sure that the screws are securely caught by the narrow sections of the
key hole opening.
WAR NING
Each speaker weighs 2.05 lbs (0.93 kg). Do not mount the speakers on thin plywood or a wall with soft
surface material, since the screws may pull away from the surface and fall. This will damage the speakers
and can cause personal injury.
Do not mount tne speakers on a wall with nails, adhesives, or any other unstable hardware. Long-term
use and vibrations may cause them to fall.
To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or
floor molding.
Secure installation is the purchaser
s responsibility.
1/4