Filter
Top Products
8 En
CONTROLS AND FUNCTIONS
■ Preparing the remote control
The remote control comes with the battery already
installed. Before using the remote control for the very first
time, pull out the insulation sheet, as shown.
y
Remove the transparent sheet before using the remote control.
■ Using the remote control
Use the remote control within 6 m (20 feet) of the
component you want to control and point it toward its
remote control sensor (see page 3).
• Be careful not to spill liquid on the remote control.
• Be careful not to drop the remote control.
• Do not leave the remote control in the following places:
– hot or humid places, such as near a heater or in a bathroom
– extremely cold places
– dusty places
■ Replacing the battery in the remote control
Change the battery when the operation range of the remote control decreases.
• Insert the battery according to the polarity markings (+ and -).
• If the battery runs out, immediately remove it from the remote control to prevent an explosion or acid leak.
• If the battery starts leaking, dispose of it immediately. Be careful not to let the leaking battery acid touch your skin or clothing.
• Before inserting a new battery, wipe the compartment clean.
• Dispose of batteries according to your regional regulations.
Insulation sheet
Notes
STANDBY ON
PHONES
VOLUME
INPUT
30˚ 30˚
STANDBY ON
CD iPod
FM
USB
SLEEP
FM
PRESET
FUNCTION
MENU
DISPLAY
FOLDER
SHUFFLE REPEAT
MUTE
VOLUME
TUNING
MEMORY
Within 6 m
(20 feet)
Notes
Use a straight pin to
remove the cover.
Replace the battery
with a new CR2025 battery.
Close the cover.