Filter
Top Products
English
E-19
Ⅵ Random sequential tape-programming
The unit will automatically program tracks in random sequential order for recording to tape.
1 Follow steps 1 – 3 on page 16.
2 Press RANDOM.
* The unit will automatically program tracks at random for
both side A and side B considering the tape’s total time.
3 Begin recording on the tape deck, and then press
on this unit.
4 The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording,
and then press or on this unit.
Notes
● Because programmed data changes every time RANDOM is
pressed, the unrecorded space at the end of each side of the
tape also varies accordingly.
● All tracks may not be programmed if the tape’s length is not
enough. To program all tracks, use a tape that is longer than
the actual playing time.
● In step 2, you can check the program data for side A and side
B.
CDX-596
CDX-496, CDX-396
1
Shows the number of tracks programmed on each side
right after the programming is finished. It is then replaced
by the number of the first programmed track on side A.
2 Shows the programmed track numbers on each side.
3 Shows the total time of programmed tracks on each side.
4 Shows the side of the tape.
● Up to 40 tracks can be programmed. A pause inserted between
side A and B is counted as one track.
● CD synchronized recording function can be used if your tape
deck is compatible with it. If so, in step 3 and 4, press
SYNCHRO and then press on this unit’s remote control.
Recording automatically begins. (For details, refer to page 21.)
RANDOM
REPEAT
4
2
3, 4
RANDOM
1
3
2 4
PROGRAM
2
12
468
A
TOTAL
PROGRAM
A
13
2
4