Yamaha CDC-635 CD Player User Manual


 
Notes
You can set as many as 20 programs at one time.
If you will make programming with the DISC 1 tray empty,
be sure to press a DISC SKIP button before starting
programming.
The total time of the programed tracks will not be displayed,
if tracks are selected from more than one disc.
The total time of the programmed tracks will not be
displayed, if a track number higher than 20 is programmed.
If, during programming, the TIME display mode-select
button is pressed, the program number display can be
changed to display the total time of the programmed tracks.
To return to the previous display, press the TIME display
mode-select button once again.
The SKIP ( and ) button can be used during
playing, but only within the range of the programmed tracks.
The SEARCH ( and ) button can be used during
playing to search through all tracks, including
unprogrammed tracks.
To stop program play
Press the STOP button. The first track number
programmed will be displayed.
To resume play, press the PLAY button. Play will begin
from the beginning of the program.
To cancel a programmed setting
There are several methods, as described below.
Press the CLEAR button while the unit is stopped.
Press the STOP button while the unit is stopped.
Open the disc tray.
Switch off the power.
To check programmed data
1. If the unit is in the play mode, press the STOP button.
2. Press the PROG button.
3. Each time the SKIP button is pressed, the track
numbers and sequential order of the programmed tracks
can be checked one after another. The display of the track
number can be returned (sequentially in reverse order) by
pressing the SKIP button.
To correct programmed data
1. Follow the procedure described in “To check programmed
data”.
2. Display the track number to be corrected by pressing the
SKIP button.
3. Press a numeric button on the remote control transmitter to
select a track to replace the one displayed. The previously
programmed track will be cleared from the memory and the
new one will be programmed.
4. After the correction has been completed, press the PROG
button or PLAY button once again.
11