Yamaha AX-592 Stereo Amplifier User Manual


 
9
English
9
Connect the SPEAKERS terminals to your speakers with cable
of the proper gauge, cut as short as possible. If the speakers
are improperly connected, no sound will be heard. Connect
each speaker making sure that the polarity (+ and –) is correct.
Red: positive (+)
Black: negative (–)
If the cables are reversed, the sound will be unnatural and will
lack bass. Do not allow exposed wires to touch each other
or metal parts; this could damage the unit and speakers.
For AX-492’s SPEAKERS A and B terminals and
for AX-592’s SPEAKERS B terminals only:
Unscrew the knob.
Insert the exposed wire.
[Remove approx. 5 mm
(1/4 in) insulation from
the speaker wires.]
Tighten the knob and
secure the wire.
Banana plug connections are also possible. Simply insert the
banana plug connector into the corresponding terminal.
(except for UK and Europe models)
One or two speaker systems can be connected to this unit.
If you connect only one speaker system, connect it to either
SPEAKERS A or B terminals.
Use speakers with the specified impedance shown on the
rear panel.
For AX-592’s SPEAKERS A terminals only and
for AX-892’s SPEAKERS A and B terminals:
CONNECTING SPEAKERS
REAR PANEL PARTS
1
2
3
2
3
1
AC OUTLETS (SWITCHED)
Use these to connect the power cords from your components
to this unit.
The power to the SWITCHED outlets is controlled by this unit’s
POWER switch or the remote control’s POWER key. These
outlets will supply power to the connected components
whenever this unit is turned on.
The maximum power (total power consumption of
components) that can be connected to the AC OUTLETS
(SWITCHED) is 100 watts.
Unscrew the knob.
Insert the exposed wire.
[Remove approx. 5 mm (1/4
in) insulation from the
speaker wires.]
Tighten the knob and secure
the wire.