Filter
Top Products
3 En
English
Installation: illustrated examples
Example 1: Unit beneath TV
Example 2: Unit without stand beneath TV (☞ P. 9)
Example 3: Wall mounting
• Do not place the unit on/under any other components such
as BD player in a pile. The vibration of the unit may cause
system failure, etc. in other components.
• Depending on your installation environment, connections
to external components such as TV or BD player can be
done before installing the unit. We recommend that you
temporarily place and arrange all components in order to
decide which procedure is best done first.
• When you clean the unit, use a clean, dry and soft cloth
(such as cloth for glasses).
• Do not touch the grille on the front and bottom of the unit.
• Place the unit away from your TV more than 50 mm (2”)
so as not to damage your TV with rear panel of the unit.
The brackets on the rear of the unit are removable.
You can attach the unit to a wall using the brackets on the
rear of the unit.
1 Attach the supplied mounting template
on a wall and mark the holes of the
mounting template.
2 Remove the mounting template and then
install the commercially available screws
and the supplied spacers at the marks.
3 Hang the unit on the screws using the
brackets on the rear of the unit.
• Do not attach the unit to a wall that is made of weak
materials such as plaster or veneered woods. Doing so may
cause the unit to fall.
• Use commercially available screws that can support the
weight of the installation.
• Make sure you use specified screws to attach the unit. Using
clamps other than specified screws, such as short screws,
nails, or two-sided tape, may cause the unit to fall.
• When connecting the unit, fix the cables in place where they
will not become loose. If your foot or hand accidentally gets
caught on a loose cable, the unit may fall.
• After attaching the unit, check that the unit is fixed
securely. Yamaha will bear no responsibility for any
accidents caused by improper installations.
Placing
Notes
Attaching the unit to a wall
When installing the unit on a wall, all
installation work must be performed by a
qualified contractor or dealer. The customer
must never attempt to perform this installation
work. Improper or inadequate installation
could cause the unit to fall, resulting in
personal injury.
Example 1 Example 2 Example 3
Notes
Tapes or
thumbtacks
Mark
7 to 9 mm
(1/4” to 3/8”)
2 to 4 mm
(1/16” to 3/16”)
Minimum
20 mm (3/4”)
4 mm (#8)
Spacer (5 mm (1/4”))