Filter
Top Products
5
Choose one of the ways listed below to connect this unit to your amplifier.
CD
LINE OUT
To AC outlet
CDX-480
Amplifier
Connection cord
(included)
➊
CDX-480
When the LINE OUT (analog) terminals of this
unit are used (
➊
)
•
Be sure that the left (“L”) and right (“R”) LINE OUT terminals
are connected to the corresponding (left and right) terminals
of the amplifier or other component.
•
Connect the “LINE OUT” terminals to the “CD” (or “AUX”)
terminals of the amplifier. If the amplifier does not have such
terminals, use the “TAPE PB” terminals. For additional
details concerning these connections, refer to the operation
instructions for the amplifier being used.
• CDX-880 only
Connect to either the VARIABLE terminals or the FIXED
terminals. (As a general rule, connect to the FIXED
terminals.)
VARIABLE: The output level of these terminals can be
adjusted by using the OUTPUT LEVEL
buttons.
FIXED: The output level of these terminals is not
variable.
CDX-880 only
When the DIGITAL OUT (OPTICAL) terminal of
this unit is used (
➋
)
•
Before using this terminal, remove the terminal’s cover by
pulling it.
•
Make the connection from this terminal to the optical input
terminal of an amplifier by using a commercially available
optical fiber cable.
* Use an optical fiber cable that conforms to EIAJ
standards. Other cables might not function correctly.
•
Be sure to attach the terminal’s cover when this terminal is
not being used, in order to protect the terminal from dust.
• The level of signals output into an amplifier is fixed to max.
and cannot be adjusted.
CDX-880 and CDX-580 only
When the DIGITAL OUT (COAXIAL) terminal of
this unit is used (
➌
)
•
Make the connection from this terminal to the digital input
terminal of an amplifier or D/A (digital-to-analog) converter
by using a connection cord.
• CDX-880 only
The level of signals output into an amplifier is fixed to max.
and cannot be adjusted.
• CDX-580 only
Adjust the level of signals output into an amplifier to max. by
using the OUTPUT LEVEL buttons.