Filter
Top Products
MAINTENANCE
Recommended Cleaning Procedures
Cleaning the fan / Circuit Board – Every 90 Days
A. The internal fan in all Xtant amplifiers need periodic cleaning.
If you are in a high dust environment, every 30 days is
recommended. We recommend that your dealer remove
the cover and clean the fan blades with a soft brush. Loose
dust can be removed with a vacuum hose.
Caution: Have your dealer check the fan for obstructions if your
amplifier over heats. When the Thermal Protection Circuit
is engaged, the orange LED will be illuminated and power
may be reduced.
B. Have your dealer check the circuit board for dust. If
present, use a low pressure air source to blow-off the dust
particles. DO NOT
use a high-pressure source, brush or
any similar device to clean the circuit board!
Cleaning the Amplifier – Every 30 days
A. Clean the stainless steel cover with a light dust cloth. For a
more thorough cleaning, use window cleaner that is
ammonia free. Apply the cleaner to the cloth (not the
amplifier) and wipe the surface. Take care not to catch the
cloth on the copper mesh.
Caution: Do not allow liquids to touch the circuit board.
B. To polish the stainless steel cover Xtant recommends the
use of WD 40™. It is important to note that stainless steel
has a (directional) grain. As a rule of thumb, always polish
with the grain. Apply the WD40™ to the cloth (not the
amplifier) and wipe the surface. Take care not to catch
the cloth on the copper mesh.
9