Filter
Top Products
- 5 -
7) In the “Source” box, select “1”, since the XT1 we want to control is connected to Source 1.
8) Click the “Accept” Button.
You have now successfully programmed the“Ç PAUSE” button in Zone 1 perform the
“Frequency Up” function of the XT1. Continue programming the rest of the MRC88m keypad
buttons to the other desired XT1 functions. (See Figure 1 at the end of this document that
shows how the Metadata commands map to an XT1 function.
Please pay attention to Figure 2 at the end of this document that shows how buttons on the
SPLCD-MRC-KP Tuner page to map the MRC88m Virtual Keypad buttons.