Xantech XOD65 Speaker User Manual


  Open as PDF
of 2
 
INSTALLATION
STEP A: The XOD speaker is intended
to be mounted using the included
bracket only. Select a desirable location
to mount the speakers. Then determine
if they are to be installed vertical or
horizontal.
STEP B: Using a bubble level, align the
speaker bracket. Secure the speaker
bracket using screws or fasteners that
are applicable for surface. Concrete or
brick surfaces require different screws
or fasteners than a painted wood
surface.
STEP C: Slide the main speaker
housing onto the mounting bracket.
Then, using the mounting knobs,
attached the main speaker housing to
the mounting bracket. Hand-tighten the
mounting knobs while moving the
speaker to a desired angle. Caution,
excessive tightening can cause damage
to the threads.
STEP D: Attached speaker wire to the XOD speaker’s gold-plated posts.
INSTALLATION COMPLETE!
XANTECH CORPORATION
13100 Telfair Avenue
Sylmar, CA 91342
Document No. 08905094A, © 2007 Xantech Corporation
This document is copyright protected. No part of this manual may be copied or reproduced in any
form without prior written consent from Xantech Corporation.
Xantech Corporation shall not be liable for operational, technical, or editorial errors/omissions
made in this document.
 previous