Xantech 490-85 KITRP Stereo Receiver User Manual


  Open as PDF
of 2
 
- 2 -
INSTALLATION INSTRUCTIONS
STEP 1:
Plug in the 2.1mm Coaxial power plug of the 781RG Power Supply (ITEM D) into the jack labeled
12VDC on the 789-44 Connecting Block (ITEM B).
Plug the AC end of the 781RG Power Supply (ITEM D) into an ‘un-switched’ 120V AC Line outlet.
STEP 2:
Plug the 3.5mm stereo mini plug from the 490-85 (ITEM A) into the IR RCVR input on the 789-44
Connecting Block (ITEM B).
STEP 3:
Plug in the 283M Emitters 3.5mm mono mini plug (ITEM C) into the jacks labeled EMITTERS on the
789-44 (ITEM B) and affix the opposite end of the IR Sensor Window of the controlled equipment.
490-85
Micro Link
LCD/CFL Friendly
IR Receivers
To 120 V AC
(Unswitched)
781RG
Power Supply
789-44
Connecting Block
283M
Blink-IR
283M
Blink-IR
MAIN ROOM
Hand Held
Remote
Satellite Receiver
AV Receiver
VCR
283M
Blink-IR
Mouse Emitter
12VDC
+12
VDC
GND
STATUS
IR IN
EMITTERS
IR
RCVR
789-44
CONNECTING BLOCK
®
Adjusting the IR Carrier Frequency
Refer to the 490-85 instruction manual for more details. The 490-85 is factory set to an IR carrier
repeat frequency of 38kHz. This will be correct for the majority of installations.
Clock-wise (CW) will increase the carrier frequency.
Counter-Clock-wise (CCW) will decrease the carrier frequency.
XANTECH CORPORATION
13100 Telfair Avenue
Sylmar, CA 91342
Phone 818-362-0353 Fax 818-362-9506
www.xantech.com
Part No. 08905114 Rev A 04-26-07
© 2007 Xantech Corporation
 previous