Xantech 17294 Rp Stereo Receiver User Manual


  Open as PDF
of 4
 
IR Receivers
3
INSTALLING THE CPL94B COUPLER:
Connect the other short coaxial cable between "SAT/VCR" on the CPL94B Coupler and the RF splitter.
Connect the room-to-room cable to "REMOTE TV" on the CPL94B Coupler.
Make the remaining connections from the RF splitter to the "OUT TO TV" on VCR, the RF splitter to the
local TV, etc., as shown in Fig. 3.
NOTE: If your main room TV has A/V input jacks, you may connect the VCR and Satellite Receiver with
A/V patch cords instead of using the RF IN jack on the TV and the RF splitter. Refer to Fig. 3 for typical
connections.
INSTALLING THE IR EMITTERS:
Plug the supplied emitters into the jacks marked "EMITTER" on the CPL94B. Next, remove the paper
backing exposing the adhesive surface of each emitter. Press the adhesive side directly into place over the
center of the infrared sensor "window" on the front panel of the satellite receiver, VCR, etc.
NOTE: It may not be possible to place emitters on the sensor of some products (such as RCA DSS
receivers). In such cases, use the high output 282M emitter placed close to the sensor or on a nearby shelf,
etc. (within 6 inches).
172-94
Fig. 4 Advanced Multiroom Hookup
282M &
283M
IR Emitters
(included)
1ST TV
RF IN
A/V INPUTS
(BACK PANEL)
VLR
MAIN ROOM
RF IN RF OUT
RF IN
OUT TO TV
TV SIGNAL PATH
IR REMOTE CONTROL PATH
Hand Held
Remote
REMOTE ROOM
120 V AC
(unswitched)
RF IN
2ND
TV
Satellite Dish
Coaxial Cable
(not included)
Place emitters on
the IR sensor
window on front
panel of each
controlled unit
(see text).
Emitter
SATELLITE
RECEIVER
(Back Panel)
VCR
(Back Panel)
Emitter
IR Sensor Windows
(Front Panel)
Coaxial Cable
(not included)
Coaxial Cable
(included)
Coaxial Cable
(not included)
CPL94B
COUPLER
(included)
Room-to-Room Coaxial Cable
(not included)
291-00 IR
RECEIVER
(included)
Coaxial Cable
(included)
INJ94 INJECTOR
(Included)
781C-00
Power Supply (included)
200-00
RF SPLITTER
2-Way
(not included)
Coaxial Cable
(not included)
A/V OUTPUTS
VLR
IN
OUT
VLR
A/V Patch Cords
(alternative connection - see text, pg 4)
IN
OUT
OUT
EMITTER
REMOTE TV
SAT/VCR
CPL94B COUPLER
EMITTER
+12 V
IR
RCVR
TV
INPUT
INJ94 INJECTOR
 previous