Filter
Top Products
11/16 XT1
5
Auto Memory
1
Start scan from the current frequency and
write each station into preset sequentially
2
Start scan from FM 87.5MHZ to 107.95 then
AM 530 to 1690, write each station into preset
sequentially.
6
RS232 Output
1
Outputs feedback one by one (i.e. on demand)
2
Outputs feedback every 0.5 seconds
3
Outputs feedback every 1 seconds
4
Outputs feedback every 2 seconds
5
Outputs feedback every 5 seconds
7
Preset Scan
1
Scan up preset number to play each preset for 5
sec
2
Scan Down preset number to play each preset
for 5 sec
3
Stop the preset scan
4
Move and stop only once at the next preset of
higher number
5
Move and stop only once at the next preset of
lower number
8
Write/Erase a
1
Enter a "0" to erase the current preset shown in
preset
the display
2
write the frequency into the entered number 01..32
9
Up/Down Tuning
1
Auto tune up frequency
2
Auto tune Down frequency
3
Manual tune up frequency one step
4
Manual tune down frequency one step
10
Stereo/Mono
mode
1
Let Tuner received signal control the mode
2
Force the tuner into Mono mode reception
(Stero mode is
set each time the auto-tuning is engaged)
11*
Get frequency
1
Output in ASCII, the band and frequency
listening
Get Preset
number
2
Output in ASCII, the preset number that is
displaying
Get Tuning mode
3
Output in ASCII, the current tuning in "auto" or
"manual"
Get Receving
mode
4
Output in ASCII, the current receiving mode in
"Stereo" or "Mono"
Get Operating
Status
5
Output in ASCII, the Frequency Preset number,
Tuning Mode, Receiving Mode, Zone ID, IR ID,
and Power status
12
Purge EEPROM
111
Purge the EEPROM and restore it to the default
setting
13
MPU Reset
111
Reset the MPU to default settings
14
Reserved for
future use