Winegard MVT-35B Satellite Radio User Manual


 
7
1. Be sure vehicle is in a location free of all obstruc-
tions and with a clear view of the southern sky.
2. DO NOT MOVE VEHICLE during the first initial-
ization. Power up unit, turn on receiver. FOR THE
FIRST TIME ONLY, the unit may take up to 10 min-
utes to initially find the satellite signal. The GPS is
also initalizing at this time. After the GPS initializes,
the unit will begin searching for the correct satellite.
3. If the GPS does not initialize at this time, turn
off the unit. You may need to move the GPS an-
tenna to a different location on your roof. After you
move the GPS, DO NOT SECURE TO ROOF.
4. TEST YOUR SYSTEM BEFORE SECURING
THE GPS ANTENNA. Make sure the TV/receiver
has found the correct satellite.
5. After the correct satellite has been found, secure
GPS antenna by removing adhesive backing and
securing to roof.
Initializing & replacing the dome after
connecting the receiver(s) —
Connecting two receivers
1. Connect the coax cable coming from the
MV3500T to the “ SATELLITE IN” input on the
primary receiver. The primary receiver is the
receiver used most often and will toggle between
satellites.
2. Run a second cable through the empty Heyco
opening and connect to the ground block-type
feed through and connect the other end of this
cable to “Satellite IN” input on the second re-
ceiver. NOTE: Secondary receiver will not
toggle.
3. See page 5 of Operations Manual for receiver
set-up.
Installation • Wiring
Connecting one receiver
1. Connect the coax cable from the MV3500T to
the “SATELLITE IN” on the receiver.
2. See page 5 of Operations Manual for receiver
set-up.
Connecting the receiver —
CONNECTOR
APPLY SILICONE BEAD IN HOLE
WHERE COAX ENTERS
APPLY SILICONE BEAD
AT BASE OF CONNECTOR
UNIT BASE
PRIMARY
RECEIVER
USED ONLY WITH
A SECONDARY
RECEIVER
GROUND BLOCK
CUSTOMER/INSTALLER
PROVIDES COAX FOR
SECOND RECEIVER