Filter
Top Products
Personal PA
™
Multi-Channel FM Receiver
• Model PPA R35-8
Personal PA
™
Multi-Channel FM Receiver
• Model PPA R35-8
ADAADA
©2008, Williams Sound Corp. MCAT
036E 2
NOTE: SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE!
The PPA R35-8 shall be a digitally synthesized eight channel receiver. The receiver shall be encased in a
black PC/ABS plastic with a hinged door on the back for battery installation.
The receiver shall be a body-pack type and include a detachable belt-clip for hands-free operation. The
receiver shall have a 3.5 mm mono phone jack and accommodate low-impedance mono earphones,
headphones and telecoil couplers. The receiver shall have a combination volume control and power
on/off rotator dial, an eight position channel select knob and a red power LED on the top bezel. The
power LED will flash to indicate low battery. There shall be a slide switch located inside the battery
compartment to select between Alkaline or NiMH rechargeable battery operation. There shall be a
squelch control located inside the battery door. There shall be drop-in charging contacts on the bottom
of the receiver.
The receiver shall be pre-programmed to eight channels between 72 and 76 MHz. The receiver shall
operate for up to 32 hours with two 1.5 volt AA NiMH rechargeable batteries and 50 hours on two
1.5 volt AA Alkaline batteries.
The R35-8 shall receive FM signals in the 72-76 MHz audio assistance band with 75 µS de-emphasis. The
receiver shall provide a maximum output of 35 mW at 16 Ohms with an earbud type earphone. The
receiver shall accept a maximum wideband deviation of ±75 kHz. The system’s electrical frequency
response shall be 40 Hz to 15 KHz ± 3dB and the signal to noise ratio shall be 60 dB at 100 µV. The
receiver shall have a sensitivity of 2 µV at 12 dB Sinad.
The receiver shall be covered by a five year parts and labor warranty, excluding earphones, headphones,
batteries and chargers.
The receiver shall be the Williams Sound Corp. model PPA R35-8.
Bid Specs: