Filter
Top Products
3
To minimize coffee spills, especially if coffeemaker is tipped over, make sure cover is secured onto
coffeemaker. Care should still be used when moving coffemaker as cover temporarily reduces spillage
if coffeemaker is tipped over.
4. Place coffeemaker on a dry, level surface. Attach cord to coffeemaker and plug into a 120 volt AC
electrical outlet ONLY.
CAUTION: To prevent personal injury or property damage, inspect cordset for damage or wear before
each use. Do not use your product if it or its cord has been damaged or if it is not working properly.
Coffee stops perking automatically when coffee is ready. Allow approximately 1-1/2 minutes brewing
time for each cup prepared. Before serving, remove cover and lift out basket and stem assembly using a
hot pad. (Depress lever on handle to release cover.) If basket and stem are not removed, bitter oils from
the coffee grounds will drip into the coffee. Replace cover, making sure it is secured onto coffeemaker.
See step 3.
5. Coffee will remain at serving temperature as long as coffeemaker is connected to outlet. When
approximately one cup remains, unplug cord from electric outlet and allow coffeemaker to cool before
cleaning.
TO MAKE MORE COFFEE:
If another pot of coffee is desired right away, clean all parts and fill coffeemaker with COLD water to reset
the thermostat. Pour out water, then refill COLD water to the desired level and repeat the steps above for
making coffee.
TO REHEAT COFFEE:
Reheated coffee never tastes as good as fresh perked, so try to brew only the amount you plan to serve. If
coffee is reheated in coffeemaker, there must be at least 3 cups in coffeemaker. Place stem and empty
basket in place and secure cover onto coffeemaker. (Using the stem and coffee basket will heat the coffee
faster and more uniformly.) Plug coffeemaker in and allow it to complete the perking cycle. Remove
basket and stem assembly. Unplug coffeemaker when 1 cup remains.
TO HEAT WATER FOR INSTANT BEVERAGES:
Plain water may be heated in your coffeemaker for use with instant beverages. Simply fill the clean
coffeemaker with cold water to the desired cup level. Place clean stem and empty coffee basket in place as
for making coffee. (Using stem and empty basket will heat the water more uniformly.) Secure cover in
place and plug coffeemaker in. Allow it to complete perking cycle. Remove basket and stem assembly.
Unplug coffeemaker when 1 cup remains.
Other than making coffee or heating water, no other liquid should be heated in coffeemaker as damage to
heating unit can occur.
When coffeemaker is used to heat water only, the metal inside will discolor which is normal and does not
affect performance or the water heated in the coffeemaker. Refer to “Special Cleaning Instructions” in this
leaflet for removing discoloration as well as mineral deposits which form inside the coffeemaker when
heating water. If these deposits are not removed, pitting of the meal inside may occur and result in damage
to coffeemaker. Refer to care and cleaning instructions as follows:
GENERAL CLEANING INSTRUCTIONS – After Each Use
Improper cleaning of the coffeemaker, especially the heating unit well, will affect performance of the
coffeemaker, resulting in weak, lukewarm coffee and may even cause the coffeemaker to stop perking.
To keep your coffeemaker working properly, it is important to follow the cleaning instructions below:
1. Unplug coffeemaker and allow to cool before cleaning.
CAUTION: To prevent personal injury or electrical shock, do not immerse coffeemaker, its cord or plugs in
water or other liquid
2. Clean basket, stem and cover in hot soapy water with a dishcloth, rinse and dry. Coffee stains on
underside of cover or stem may be removed by scouring with a damp cloth and a non-abrasive