Filter
Top Products
9
Connections ____________________
This section provides instructions to connect the Wadia 301 CD to the
rest of your music system. Below is an illustration of the Wadia 301 CD
rear panel, showing all inputs and outputs.
Avoid allowing static shocks to be applied to the inputs or outputs. To
prevent static shocks, touch any grounded surface, such as the chassis
of a component that is plugged into an AC socket, before connecting
or removing a cable. It is unlikely that a static shock will damage the
unit, but it may cause the Wadia 301 CD circuitry to lock-up (see
Trouble Shooting in Appendices).
Inputs and outputs can be safely connected to the Wadia 301 CD:
• When the AC power is switched off OR
• When the unit is in Relay-Mute mode (See Mute in Operation)
Connecting to AC Power
Check to make sure your Wadia 301 CD has been manufactured for
operation at your AC line voltage. Attempting to use your Wadia 301
CD at any voltage other than specified on the rear of the unit may
cause damage that is not covered by Wadia’s warranty.
DES IGNED & M ANUFA CTURED
IN THE U.S.A.
IR IN
IR OUT
IN 1
RL
ANALOG OUTPUT
DIGITAL OUTPUT
LEFT
IN 2 IN 3 IN 4
IR pass through
(page 14)
Digital inputs (Optional)
(page 14)
Analog outputs
(page 10)
Digital output
(page 14)
Maximum Output Level Adjustment
(page 13)
AC inlet and power switch
(page 9)
RI GHT