Filter
Top Products
9
1. POWER - Use this button to turn the DA-8808VE ON or OFF.
2. INPUT SELECTOR - These 4 buttons allow you to select between DVD, LD, CDG and standard CD player
output to the DA-8808VE. This allows the DA-8808VE to differentiate between all the related source AUDIO
INPUT options available on the back panel.
3. KEY CONTROL -
4. LED METER - The LED METER displays stereo output levels for the DA-2808VE mix. The optimal level for
a clean, undistorted signal at high output is to show only occasional peaking in the red LED range. Lower
the MUSIC VOLUME and MIC MASTER VOLUME if red LEDs are frequent.
5. MIC MASTER VOLUME - This control adjusts the mixed output level for MIC 1, MIC 2 and MIC 3. Turn
clockwise to increase and counter-clockwise to decrease the MIC VOLUME.
6. MUSIC VOLUME - This control adjusts the output level for whichever player connected to an
AUDIO INPUT is assigned with the INPUT SELECTOR.
7. SPEAKERS A/B - These buttons switch between 2 sets of SPEAKER OUTPUT.
8. LED GAIN - Select between a HIGH or FLAT LED display mode for different effect and visibility.
Front panel descriptions and functions
Digital Key Control
Digital Key Display
+
2
Power
DVD CDG
Digital Karaoke Amplifier With Vocal Enhancer
DA-8808VE
CDLD
Vocal
Partner
High
Flat
Vocal
Cancel
High Low
Process
Digital Key Control
Digital Key Display
Mic Master Volume Music Volume
Tune
BA
Speakers MultipexLED Gain
Input Selector
Vocal Enhancer
Music Tone
Loudness
Remote
Sensor
Digital Echo
Mic Tone Mic Volume Mic Inputs
Delay
Repeat
Echo
Bass
0
10
0 10Bottom
Top
On
On
1kHz 8kHz
Treble
Mic 1
Bass Treble Balance
Mic 1 Mic 2 Mic 2Mic 3 Mic 3
Off
Off
1
2
7
8
3
4
5
6
You can adjust the key of your source music in half-step
increments to match the natural range of your voice using the KEY CONTROL
buttons. To flat (b) or lower the key, press the left KEY CONTROL button. To
sharp (#) or raise the key, press the right button. To return to the original
key of the music input source, press the center button. You will see the
DIGITAL KEY DISPLAY reflect the number of steps you have increased or
decreased displayed as numerals with +/-, or 0 for the original key.