Filter
Top Products
LED Indicators are located here:
The LED Indicators will behave differently with each button on the remote control.
Function LED Behavior Description
Input
Press the INPUT button on the remote to cycle through each available input:
• Analog Audio In - AUX (1)
• Analog Audio In - AUX (2)
• Coaxial In- Digital (3)
• Digital Optical Audio In - Optical (4)
• Bluetooth
Bluetooth Pairing
(When searching for device)
Flash from Left to Right
and back continuously.
Press and hold the button on the remote. The Sound Bar will be discoverable for 15
minutes. You can now search for the Sound Bar (VIZIO S2920w) using your Bluetooth Device.
The sound bar will power down if no device is found.
Note: Set your Bluetooth device into pairing mode prior to the Sound Bar.
DTS TruVolume
On/Off
TruVolume On:
TruVolume Off:
Press the TVOL button to enable/disable TruVolume. When enabled (On), TruVolume
provides a consistent and comfortable volume level for a more enjoyable listening
experience.
DTS TruSurround
On/Off
TruSurround On:
TruSurround Off:
Press the TSHD button to enable/disable DTS TruSurround. When enabled (On), all inputs will
produce virtual surround sound. When disabled (Off), all sources will playback in stereo.
Treble Levels
Two center LEDs indicate
Treble level 0.
Press the TREBLE button then press the Next/Previous button to increase/decrease the
treble level. The LED indicators will move to the right with increasing levels and to the left with
decreasing levels.
Bass Levels
Two center LEDs indicate
Bass level 0.
Press the BASS button then press the Next/Previous button to increase/decrease the bass
level. The LED indicators will move to the right with increasing levels and to the left with
decreasing levels.
Analog Audio In - AUX (1)
Analog Audio In - AUX (2)
Coaxial In - Digital (3)
Digital Optical Audio In -
Optical (4)
Bluetooth
LED INDICATORS